Forsiden > BOATS > Hulls/Skrog m/HardWare > Princess Yacht - Hull w/HW - 960mm (With decals)

Klikk for større bilde

Princess Yacht - Hull w/HW - 960mm (With decals)

  • På lager
  • Kr 4 399,00


    Beskrivelse

     

    Princess Yacht  - Fiberglass - 960mm (Hull with hardware)


    Most of the general RC boats in this class are made from moulded plastic material. This boat is made by 4 layer ultra strength fiberglass material. Every part and the hull itself are finished by hand Made procedures, which gives it a awsom look and finish.

    It's not only stronger than a normal boat, but it also reduces the friction against the water surface during accelerations.

    The boat is 960cm long and can with the right setup reast 70km/h.

    If you are looking for one of the best, if not the best quality on the market, this is it. 


    Included:
    • 960mm 4 layer hull with decals
    • Hardware includedHarHNNeraWa
    Spesifikasjoner:
    • 960mm 4 layer hull with decals
    • Propeller: 2 blade CNC alu propell 
    • Drive line included - Drive system 5.0 x 4.0mm collect, 4mm flex cable, 4mm drive shaft, 4mm drive dog
    • Rudder: Lenght =43mm, high=75mmRrrr

    To make it compleet, you need:

    • Radio transmitter and receiver
    • Motor
    • ESC
    • Batteries
    • Charger
       

    We will support you to select the products you need based on your request and ambitions.