Forsiden > BOATS > Hulls/Skrog > Princess Yacht - Hull - 960mm (With decals)

Klikk for større bilde

Princess Yacht - Hull - 960mm (With decals)
BESTILLINGSVARE - Leveringstid ca. 4 uker.

  • På lager
  • Kr 2 999,00


    Beskrivelse

     

    Princess Yacht  - Fiberglass - 960mm (Hull)


    Most of the general RC boats in this class are made from moulded plastic material. This boat is made by 4 layer ultra strength fiberglass material. Every part and the hull itself are finished by hand Made procedures, which gives it a awsom look and finish.

    It's not only stronger than a normal boat, but it also reduces the friction against the water surface during accelerations.

    The boat is 960cm long and can with the right setup reast 70km/h.

    If you are looking for one of the best, if not the best quality on the market, this is it. 


    Included:
    • 960mm 4 layer hull with decals (rudder and stingers shown in the picture is just for illustration.)raWa
    Spesifikasjoner:
    • Length: 960mm
    • Beam/Wide: 230mm
    • Hight: 250mm
    • Hull type: 4 layer Fiberglass (FRP)

    To make it compleet, you need:

    • Radio transmitter and receiver
    • Needed hardware (stinger, axcel, etc)
    • Motor
    • ESC
    • Batteries
    • Charger
       

    We will support you to select the products you need based on your request and ambitions.